40000133.qxd
Condenser
Support the container with both hands. When full, the water container will weigh about 4kg (fig. 7).
7 |
3.Open the lid located on the top of the container and empty the water (fig. 8).
8
4.Refit the lid and slide the water container back into position. PUSH
FIRMLY INTO PLACE.
5.Refit the kickplate by engaging the hinges at the top and ‘snapping’ the lower clips into place.
Condenser
IMPORTANT: Always switch off and remove the plug from the electricity supply before cleaning the condenser.
To maintain the efficiency of the dryer regularly check that the condenser is clean.
To remove the condenser:
1. Remove the kickplate (fig. 5).
2.Turn the two locking levers anti- clockwise (fig. 9).
9 |
3. Pull out the condenser unit (fig. 10).
10 |
4.Gently remove any dust or fluff with a cloth, then wash the unit by holding it under a running tap (fig. 11) turning it so that water flows between the plates, to remove any dust or fluff.
11 |
5.Refit the condenser ensuring it is in the correct way (as indicated by the arrow) and pushed firmly into place. Lock the two levers by turning them clockwise.
6.Refit the kickplate.
7