Variable Steam Function

min	ax
	m

Set the variable steam control to required steam volume. Steam can only be produced when the thermostat is in the red cotton/ linen zone. Allow iron to heat up (light goes out) before activating the variable steam control. Reduce or set variable steam to min. when ironing at low temperatures to avoid water leakage or spitting.

Iron ready for steam ironing

Steam is produced as soon as the iron is held horizontally.

Steam off

Steam generation can be interrupted:

by standing the iron on its heel or

by sliding the variable steam control completely to min

SPRAY SETTING

Ensure there is water in the tank.

Moistening the fabric with the spray will make wrinkle removal easier.

Press the spray button down slowly for a jet or quickly and strongly for a mist.

Do not spray silk, etc.

BURST OF STEAM

To remove stubborn wrinkles or press in a sharp crease, use the burst of steam button.

Press the button firmly, a strong burst of steam penetrates deep into the fabric.

Leave an interval of at least four seconds between pressing the burst of steam button.

With water in the tank, the burst of steam button can be used as soon as the steam ironing temperature has been reached (●●●)