USING FOR THE FIRST TIME
Please read the instructions for use and the Important Safety instructions carefully.
It is normal for a small amount of smoke to be produced the first
time the appliance is used. This will quickly disappear.
When the appliance is plugged in, and thermostat control dial is moved from the minimum setting, the soleplate
heats. Do not touch or remove the sole- plate cover without letting the appliance cool down.
During use or while unit is heating or cooling, do not rest appliance on its sole- plate. Place product on its side on a firm, heat resistant, flat surface, as soleplate will be hot.
As the appliance heats the housing becomes warm.This is normal.
DUAL VOLTAGE
240 V
120V
Dual voltage selection
The appliance can work on both, 120V or 240V, AC systems.
Be sure the dual voltage selector (E) is in the correct voltage position before oper- ating. To do this, unplug the appliance and turn the selector which is below the handle with a coin, so it is aligned with the correct voltage (either 120V or 240V).
!Never change selector while unit is plugged in.
This is a 120/240 V dual voltage appliance and may be used in the United States and abroad without an electricity converter.
An adapter plug may be necessary when using appliance in foreign countries. If needed, plug the steambrush into correct adapter plug for the specific country and plug assembly into electrical outlet.
Dual voltage selector in wrong position
If the voltage selector is set to 240 V in a 120 V supply, the performance of the Steambrush will be reduced.
Never set the voltage selector to 120 V in a
FILLING THE WATER TANK
Before plugging in the Steam 'n Press fill the water tank (C) with water as follows:
Remove the water tank
To remove the water tank, hold on to the bottom half of the handle and slide the top half of the handle away from the appliance as shown.
5