Filling the water tank

Remove cap, fill the tank with ordinary tap water and close the cap.

Replacing the water tank

Put the full water tank back into the unit, by sliding the lower handle back into the top half of the handle until it is firmly in place.

Adding water during use

Always unplug the appliance and wait for it to cool down before removing the water tank.

Handle with care as unit will remain hot for a considerable time.

Fill as indicated in water tank filling section.

Plug in the appliance and wait approximately one minute to ensure your Steam 'n Press is fully reheated before using it.

ATTACHING AND REMOVING THE SOLEPLATE COVER

Attaching the soleplate cover

The Steam 'n Press should be unplugged and completely cool when removing or attaching the soleplate cover.

To attach the soleplate cover (K) to

the Steam 'n Press, hold the soleplate cover by the ribbed finger grips (J) and slide the cover over the soleplate.

Turn the soleplate cover lock (G) half a turn (180° ) to the left to lock the soleplate

cover into position.

Your appliance can be used as a Steambrush once cover is attached. Reference “Steambrush Function“ section of instructions for further use information.