40000287.qxd 13/11/2003 13:02 Page 8
If the inlet hose’s connection point is changed, check that the 3/4” threaded ferrule on the inlet hose is firmly attached to the electrovalve connector.
Water supply requirements
Connect the machine to the drainage system used by household sinks.
THIS MACHINE MUST BE CONNECTED IN
ACCORDANCE WITH THE WATER SUPPLY
REGULATIONS. WATER BYELAWS PROHIBIT
CONNECTION TO A SURFACE WATER DRAIN.
No other appliance should be plumbed into the standpipe.
There are two possible arrangements which can be seen below :-
HOSE SUPPORT
CROOK
DRAIN HOSE
32mm
min 80cm
| FIX SECURELY |
| ABOVE OVERFLOW |
HOSE SUPPORT CROOK | OUTLET OF SINK |
DRAIN HOSE
ATTACH HOSE
SECURELY TO
WASTE OUTLET
For the washing machine to function properly the outlet end of the drain hose must be at a minimum of 60 cm and a maximum of 80 cm from the ground.
8