05651318.qxd
Installation & testing
Remove the machine from the packaging - close to where it will finally be positioned - and proceed as follows:
On the back of the machine
1) Remove the central screw A and side screws B and pull out the transit bracket C along with the red locator.
2) Tilt the machine forward and remove the polystyrene spacers.
3) Cover the central hole using the cap
enclosed in the instructions bag.
4)Adjust the two feet at the front to level the machine.
5)Tilt the machine forward and locate
the base panel by (1) removing the paper backing from the adhesive tape,
(2) locate the base panel in the front of the machine, (3) offer the base panel up to the base of the washing machine and locate the two push clips.
6