Noise, Other, Washer is noisy, Peel off cleanly

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

NOISE	Possible Causes	What To Do

Washer is noisy	Washer is uneven	• To level the front of the washer, adjust the front leveling
		legs by rotating the individual leg in the proper direction
		for up or down. To level back of washer, lift back of
		machine 4″ (11 cm) and set down.

	Washer load is unbalanced	• Push the Cycle knob in to stop the washer, open the lid
		and redistribute the load evenly. Close the lid and restart.

	Shipping rod is still assembled	• To remove shipping rod from washer, pull yellow tag and
	in unit	attached rod from the bottom right hand side of washer.

	Washer is sitting too close to wall, • Pull washer away from the wall; about 4″ (11 cm)
	causing knocking during cycle	is needed.

	Whistle or knock during fill	• Normal sounds during fill include the water filling
		in through the house plumbing. As the water pressure
		goes up and down, a knock or hammer can develop.
		Make sure the water faucets are fully turned on.

	Clanking or clunking	• Many washers have features such as pulse agitation and
		pauses during rinse and spin for reduced clothes wear
		and to reduce likelihood of soap residue. These short
		pauses of less than 1 minute are normal and will reduce
		clothing wear and increase water extraction. Sounds such
		as a metallic knock, double knock or metallic clunk occur
		when the washer transitions from a stop or paused state
		to running or spinning. They occur several times per cycle
		after speed changes or pauses.

OTHER	Possible Causes	What To Do

Labels on the exterior	Occasionally the adhesive	• Use a hair dryer set at the lowest heat setting, directing
of the washer will not	used on the labels does	the air at the label for a short amount of time. This will
peel off cleanly	not release cleanly	release the adhesive easily, without damaging the surface
		of the washer.

NOISE