Black & Decker D1500C manual Important Safeguards, Please Read and Save this Use and Care Book

Page 2

Please Read and Save this Use and Care Book.

IMPORTANT SAFEGUARDS

When using your iron, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING.

Use iron only for its intended use.

To protect against a risk of electric shock, do not immerse the iron in water or other liquid.

The iron should always be turned OFF (0) (refer to How to Use section) before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead grasp plug and pull to disconnect.

Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around the iron when storing.

Always disconnect iron from electrical outlet when filling with or emptying of water and when not in use.

Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, take it to a qualified serviceman for examination and repair. Incorrect reassembly can cause a risk of electric shock when the iron is used.

Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board.

Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down or use the surge of steam — there may be hot water in the water tank. Avoid rapid movement of iron to minimize hot water spillage.

SPECIAL INSTRUCTIONS

To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.

If an extension cord is absolutely necessary, a cord rated at 15-amperes and 120-volt, or 7-ampere and 220-volt cord should be used.

Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS.

This product is for household use only.

POLARIZED PLUG

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.

TAMPER-RESISTANT SCREW

Warning : This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electric shock, do not attempt to remove the outer cover. There are no user- serviceable parts inside. Repair should be done only by authorized service personnel.

Note: If the power supply cord is damaged, it should be replaced by qualified personnel; in Latin America, by an authorized service center.

ENGLISH





Image 2
Contents To register your product, go to For online customer serviceDigital ADvANTAGE Iron FER Digital ADvANTAGEMD Important Safeguards Please Read and Save this Use and Care BookHow to Use Product may vary slightly from what is illustratedSymbols Getting StartedAnti Drip System SpraySmart Steam Technology Digital Display LanguageNeed HELP? Care and CleaningAuto Clean System Importantes Mises EN Garde Fiche Polarisée Modèles de 120 V seulementLe produit peut différer légèrement de celui illustré SymbolesUtilisation Modes darrêt automatique Vertical Langue DE L’AFFICHAGE Numérique Auto Nettoyage Auto CleanmdEntretien et nettoyage Besoin D’AIDE? Copyright 2009 Applica Consumer Products, Inc