Filling Water Reservoir with Water

USING THE COMPACT FABRIC STEAMER

1.Place Compact Fabric Steamer on a flat, level surface.

2.Make sure grounded power cord is unplugged from electrical outlet.

3.If unit has been in use, allow it to cool for at least 5 minutes.

WARNING: Always allow unit to cool before adding water. Cold water added to a hot boiler may cause hot water and steam to shoot out of fill hole.

4.Cautiously unscrew and remove Water Reservoir Cap.

5.Carefully fill Water Reservoir with water from a faucet or cup. Pay attention to water level in Water Reservoir using Reservoir Level Window on side of unit, and fill up to the MAX (7 oz.) fill line.

NOTE: To prolong the life of your Compact Fabric Steamer, we recommend using distilled or de-mineralized water.

WARNING: Extreme caution should be used when pouring water into the Water Reservoir. Do not look directly down into fill hole when filling. Keep your free hand and any children or pets at a safe distance.

NOTE: Do not exceed the MAX fill line. Too much water in the Water Reservoir may cause excess water spitting in steam.

9.Replace Water Reservoir Cap, using care not to over-tighten it.

ATTACHING ACCESSORIES

1.Choose either the Lint Remover or Fabric Brush and insert it into Rubber Accessory Housing as shown (FIGURE 1).

2.Slide Rubber Accessory Housing (with inserted accessory) onto Steam Nozzle as shown ( FIGURE 2). Make sure that holes on Steam Nozzle are aligned with open slot on Rubber Accessory Housing so that steam is not blocked.

NOTE: Attaching accessories will help reduce water spitting in steam.

FIGURE 1	FIGURE 2
Top Innovations, Inc.	7