Tricity Bendix WDR 1040 W, WDR 1240 W installation instructions Something Not Working

Page 20

Something Not Working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.

IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Symptom

Possible causes

 

 

 

The machine does not start

The door has not been closed.

 

The plug is not properly inserted in the power socket.

 

There is no supply at the socket

 

The main fuse or the fuse in the plug has blown.

 

The selector dial is not correctly positioned.

 

The ON/OFF

button has not been depressed.

 

 

 

The machine does not fill

Ensure the water tap is open.

 

The filters in the inlet hose is blocked.

 

The inlet hose may be squashed or kinked.

 

The door has not been closed.

 

 

 

The machine fills then empties

The end of the drain hose is too low.

immediately

The end of the drain hose is submerged in water.

 

There is no vent in the end of the drain hose.

 

 

 

The machine does not empty and/or

The drain hose may be squashed or kinked.

does not spin

A programme which ends with water in tub has been selected.

 

The drain filter may be blocked.

 

The drain hose extension, if fitted, is not correct. Follow the

 

 

instructions for connecting to the waste.

 

The drainage system pipes are blocked.

 

The wash load is unbalanced: redistribute the clothes inside the drum to

 

 

allow the machine to spin.

 

 

 

There is water on the floor

Too much detergent or unsuitable detergent has been used (creates too

 

 

much foam).

 

 

Check whether there are any leaks from one of the inlet hose fitting. It

 

 

is not always easy to see this as the water runs down the hose; check to

 

 

see if it is damp.

 

 

The drain hose may be damaged or not securely positioned.

 

The detergent dispenser drawer or recess is clogged.

 

The drainage system pipes are blocked.

 

 

 

Unsatisfactory washing results

Too little detergent or unsuitable detergent has been used. An

 

 

insufficient amount of detergent leaves the laundry looking grey and

 

 

causes lime scale to form.

 

Stubborn stains have not been treated prior to washing

 

The correct wash programme has not been selected.

 

Too much laundry has been placed in the drum.

The machine vibrates when spinning The internal packing has not been removed.

The machine is in contact with the wall or furniture.

The machine is not stable and level (check diagonally).

The washing load is badly distributed in the drum.

Maybe there is very little laundry in the drum.

20

Image 20
Contents WDR 1040 W WDR 1240 W Use InstallationChild Safety Contents Interest Environment Your New Washer-DryerEcological hints Description of the Appliance Detergent dispenser drawerControl Panel Operating Sequence At the end of the programme Select the programme Washing 2 KG of Mixed Fabrics AT 50CSelect the required time Drying 2.25 KG of CottonAutodrying 1 KG of Mixed Fabrics Washing and Drying Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing Programmes Type of laundryMixed FabricsQuick CoolDrying Programmes Type of fabric Max. load Spin speedMaintenance and Cleaning Water inlet filter Something Not Working Service & Spare Parts Symptom Possible causes0870 5 Customer CareGuarantee Conditions Standard guarantee conditionsEuropean guarantee This guarantee does not coverInstallation Instructions Technical SpecificationsWashing DryingPositioning Installation on a Suspended FloorUnpacking Appliance must be connected to a cold water supply Water inletWater drainage Interest of the environment LevellingSpecial conditions Electrical connection Permanent connectionConsumer care telephone number 08705