Tricity Bendix WDR 1240 W, WDR 1040 W installation instructions Water inlet, Water drainage

Page 25

Water inlet

Connect the hose to a tap with a 3/4” thread.

Do not use previously used hoses for water connection.

P1088

Installation should comply with local water authority and building regulations’ requirements.

The appliance must be connected to a cold water supply.

A minimum water pressure of 50 kPa (0.5 bar) is required for safe operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

P0021

Water drainage

This appliance is designed to be permanently plumbed into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied.

(12")cm

30

P1074

The standpipe should have an internal diameter of approximately 38mm (see diagram) thus ensuring there is an air break between the drain hose and standpipe.

cm.(12")30Min.

38 mm.(1/2") diameter

standpipe

P1040

When discharging into a standpipe ensure that the top of the curve in the hose end is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level.

The upright standpipe should have a minimum length of 30cm (12'') from the bottom of the elbow to the top of the pipe (see diagram).

3 pin

 

Max. 90 cm. (35.4")

Min.60 cm. (23.6")

P1130

 

Make sure that it is designed in such a way, that the end of the drain hose cannot be covered with water.

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18mm.

25

Image 25
Contents WDR 1040 W WDR 1240 W Child Safety InstallationUse Contents Ecological hints Your New Washer-DryerInterest Environment Detergent dispenser drawer Description of the ApplianceControl Panel Operating Sequence At the end of the programme Washing 2 KG of Mixed Fabrics AT 50C Select the programmeDrying 2.25 KG of Cotton Select the required timeAutodrying 1 KG of Mixed Fabrics 1000g = 1 kg Washing and Drying HintsWhich form? Which detergent?Important Notes Wash Care SymbolsType of laundry Washing ProgrammesFabrics MixedQuick CoolType of fabric Max. load Spin speed Drying ProgrammesMaintenance and Cleaning Water inlet filter Something Not Working Symptom Possible causes Service & Spare Parts0870 5 Customer CareStandard guarantee conditions Guarantee ConditionsEuropean guarantee This guarantee does not coverTechnical Specifications Installation InstructionsWashing DryingUnpacking Installation on a Suspended FloorPositioning Water drainage Water inletAppliance must be connected to a cold water supply Special conditions LevellingInterest of the environment Permanent connection Electrical connectionConsumer care telephone number 08705