Tricity Bendix TBWM 1110 Water drainage, Joining piece must have an internal diameter of 18mm

Page 23

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum vertical distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Set the hoses correctly by loosening the ring nuts. After positioning the inlet hoses, be sure to tighten the ring nuts again to prevent leaks.

When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level.

3 pin

 

60 cm (23.6”)

Max. 90 cm (35.4”)

Min.

 

P1088

P0021

P1201

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre.

The joining piece must have an internal diameter of 18mm.

If your drain hose looks like this (see below) you do not require the “U” piece”. Just push the hose firmly into

Water drainage

This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain hose using the “U” piece” supplied.

U” piece supplied

P1199

Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.

38 mm (11.2”)

standpipe diameter

cm30 2")1(

P1200

the standpipe.

P1212

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

P1197

Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.

23

Image 23
Contents Tbwm Use InstallationChild Safety Contents Interest of the environment Your New Washing MachineEcological hints Prewash Main wash Fabric softener Child safety featureDescription of the Appliance Detergent dispenser drawerSpin button Control PanelDetergent dispenser drawer Mains-on light On/Off buttonStart/pause button Prewash buttonExtra rinse button Easy iron buttonOpening the door after the programme has started Programme informationAltering an option or a running programme Interrupting a programmeSelect the required programme Switch the machine onOperating Sequence Load the laundryLight corresponding to the pressed button illuminates Start the programmeSelect the required options At the end of the programme1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsWashing Programmes Mini Special ProgrammesMin Soak Maintenance and Cleaning Water inlet filter Emergency emptying outSomething Not Working Customer Care Department Service & Spare PartsSymptom Possible causes 0870 5This guarantee does not cover Guarantee ConditionsStandard guarantee conditions European guaranteeTechnical Specifications Installation InstructionsAppliance must be connected to a cold water supply UnpackingPositioning Water inletStandpipe Water drainageJoining piece must have an internal diameter of 18mm Into a drainage standpipeSpecial conditions LevellingBlue- Neutral Brown- Live Electrical connectionPermanent connection Building-in Preparation and assembly of the doorFront view Consumer care telephone number 08705