Operating Sequence

Before using your tumble dryer for the first time, we recommend you place a few damp cloths inside the appliance and dry for 20 minutes.

There may be dust inside a brand new tumble dryer.

Drying

1.Connect the appliance.

2.Open the door as per picture.

After each use

•Clean the filters (see page 9).

•Empty the water reservoir (see page 10).

Important!

If the drying programme has to be stopped before it reaches the end, we recommend that you turn the Time Selector Dial to position (cooling) and wait until the end of this phase before removing the

P1149

P1108

laundry. This will avoid a build-up of heat inside the appliance.

Modifying the programme

To change a programme which is running, turn the Time Selector Dial clockwise to the required position.

3.Load the items one at a time, shaking them out loosely.

4.Close the door. Please check the laundry does not get caught between the door and filter.

5.Select the drying time by turning the Time Selector Dial clockwise.

6.If required, press the “low heat” Button.

7.Press the Start Button: the machine starts operating. The “mains on” light comes on.

The drum turns alternately in both directions during drying.

All drying programmes end with a 10 minute cooling phase (position on selector dial). The machine stops

automatically at the end of this phase (knob pointer on position “O”). The mains-on light goes out.

8.Immediately remove the laundry.