Russell Hobbs RH1250TW, RH1250RTG instruction manual Levelling the machine, Electrical connection

Page 8

Levelling the machine

∙Your machine should be installed on a hard surface – do not install onto a carpet.

∙For your machine to work quietly and without any vibration, it should it be settled on a flat, non-slippery and tough ground.

∙Loosen the plastic adjustment nut.

∙Adjust the feet upward and downward by rotating them clockwise and anti clockwise.

∙When the correct balance has been achieved, tighten the plastic adjustment nut again by rotating it upwards.

∙Never put cardboard, wood or other materials under your machine to try and stabilise the unit.

Electrical connection

∙Your washing machine is set to 220-240V and 50Hz.

∙The mains cord of your washing machine is equipped with a specific grounded plug. This plug should always be inserted to a grounded socket of 13 amps. The current value of the fuse should be 10 amps.

∙We do not take responsibility for any damage that occurs due to ungrounded usage.

∙Operating your machine under low voltage will cause the life cycle of your machine to be reduced and its performance to be restricted.

For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084 -8-

Image 8
Contents Washing Machine 01204 664Contents Error Messages Energy Efficiency Safety Warnings Before UseRecommendations Back ComponentsFront Installation Removing transportation boltsLevelling the machine Electrical connectionWater discharge connection Only a qualified engineer should install this machineWater inlet connection Technical specifications Preparing your laundry Using your machine DetergentControl Panel Detergent DrawerSelecting a Programme Electronic DisplayBefore Use First WashAdditional Functions Half Load DetectionTwinjet system Temperature C Programme selectionAdditional Functions Spin SpeedTemperature selection Pre WashEasy Iron Delay TimerRapid Wash Anti-Allergy Function Start/Pause buttonAdding/Removing Laundry Child LockFinishing programme Cancelling a ProgrammeProgramme End Water cut off / Low Mains Pressure Blocked pump filterMaintenance and Cleaning Water Inlet FiltersCleaning the pump Cleaning the detergent drawer Cleaning your machine∙ Do not wash your detergent drawer in a dishwasher Drawer filterDrum Trouble ShootingBody Fault Possible Cause Removing Methods Error Messages Tap may be off Energy Efficiency BL6 9AJ