Smartek ST-1200 manual HOW to Fill with Water, HOW to USE AS a Steam Iron

HOW TO FILL WITH WATER

Make sure the iron is turned off and the AC Power Cord is unplugged from the electrical outlet.

1.Set the Variable steam knob to the ‘0’ position before filling the iron with water.

2.Open the Water Fill Opening and fill the Tank up to the “MAX” Line on the tank.

3.The water level can be observed through the transparent part of the tank, when iron placed vertically. When the water level becomes low, refill the tank, following the procedure described in steps 1 to 3 above.

4.Pour out the remaining water after use.

NOTE:

Most tap water can be used in this iron. Do not use water additives or substitute water such as linen or scented water in the steam iron, they can stain fabrics or damage the iron. Do not fill the water more than the “MAX” position.

HOW TO USE AS A STEAM IRON

Fill the iron as described in “HOW TO FILL WITH WATER”.

1.Position the iron vertically and turn the Temperature Control Dial to the steam position.

2.Plug the AC Cord into the electrical outlet.

3.Set the Temperature Control Dial to the steam position. Steam Ironing is only possible when at higher temperature settings indicated with ‘MAX’ mark; otherwise the water will leak from the soleplate.

4.Preheat the iron until the indicator light goes out. The light will turn off when the indicated setting reaches the correct temperature.

5.Turn the Variable Steam Control Knob to the required setting for different types of fabric.

Now steam ironing can begin.

- 7 -