Connect the water supply hose
That the appliance is to be connected to the water faucet using new water tap adaptor and water supply hose and that old one should not be reused.
1.Loosen the 4 screws on the water tap adaptor just enough to slip the adaptor over the mouth of the faucet.
2.Slip the water tap adaptor over the faucet, keeping it in a straight line with the faucet. Tighten the screws, applying even pressure all around. When the space behind washing machine is narrow due to a wall or other obstacle, adjust the back screw to the proper position before slipping the connector over the faucet.
3.Remove the tape and tighten B by turning it to the right.
4.With the water supply hose cover and lever pushed down, slide the hose up onto the proper position release them before hear it click into place.
5.Pull down on the hose to make sure it will not come off.
6.Turn on the water faucet to check for leaks.
Screws (4)
Water faucet
Water tap
adaptor | A | |
B | ||
| ||
Lever | Water supply | |
| ||
| hose cover |
[Note]
•Firmly tighten part B of the water tap adaptor, otherwise water leakage will result.
•If a water tap adaptor is already connected, replace with the attached new one.
•When the hose must be reinstalled (after you remove, for example), turn B to the left until about 4 mm of the thread becomes visible, then carry out the procedure described above.
Approx. 4 mm
B
Water
Supply Hose
Drain hose
Hose extension
Connect the water supply hose to the water supply valve screw.
Elbow
Water supply valve screw
Nut
1.Push the water supply hose nut straights onto the water supply valve screw.
2.Hold the elbow by lifting it up, screw the nut onto the water supply valve screw, and firmly tighten the nut.
3.After the nut is tightened, check whether or not the elbow is unsteady or loose.
4.After tightening, open the faucet to confirm that there is no water leakage.
[Cautions]
•Firmly tighten the nut, otherwise water leakage will result.
•Water Pressure Rating : 2.9 x 104 – 9.8 x 105 Pa
If extended external part is necessary when connecting the drain hose, the length of the drain hose should be less than 3 m and the height should be below 10 cm.
Do not put hose tip under the water
Below 10 cm.
3 m max.
Good Example | Over 10 cm |
Install the machine 10 cm or more away from the wall.
20
9/17/08 9:45:47 AM