Cleaning the drain filter
Take care not to burn yourself while handling your clothes or touching the inside of the drum after a high temperature wash.
Before cleaning the drain filter, switch off and unplug the washing machine.
1 Open and remove the drain filter cover.
Drain filter
Pump hose | Cap |
2 Take the pump hose out, remove the cap to drain the water, and put them back to the original position after all the water drains away. (Max 6L)
3 Carefully loosen the drain filter. More water may drain out - this is normal.
4 Turn it anticlockwise, unscrew the filter and remove it.
5 Remove any lint and debris before carefully replacing the filter.
6 In order to return filter to where it was
1)Set filter by joining mark of filter and mark of washer body side.
2)Turn right until reach to mark of washer body.
Preventing a frozen water supply hose
*If your washing machine is delivered in freezing weather conditions, leave it at room temperature for 24 hours after you’ve set it up before using it. This ensures there’s no ice blocking the water supply hose.
If your water supply hose freezes:
1 Wrap warm towels around the joints in the water supply hose.
Tap 
Joints
2 Add two or three litres of warm water to the drum.
about
50°C
3 Run a Drain only programme, using the MODE button.
*Make sure you replace the filter tightly. If it’s still loose, you’ll get an error message and may not be able to use the washing machine again until you tighten it securely. (see page 32)
Maintenance
29
2009/08/05 | 11:34:09 |
|
|
|
|
|
| ||
|
|
| ||
|
|
|
|
|