Troubleshooting
Problem
Cause
washing machine
Wash
Rinse/Spin
Time
30
●While the washing machine is washing, you cannot change
Buttons don’t work the programme, temperature and process settings (but you
can change the rinse or spin settings).
●Door lock may be active. (see page 9)
●Child safety lock may be active.(see page 26)
Door doesn’t open ●The water temperature or level could be too high.
●Clothing may be caught in the door. If so, press the door opening button while pushing the door.
●Rubber parts may give off a smell when you first start using
Unusual odour | the washing machine, but this goes away over time. | |
●You can wash the drum by running the Tub Clean | ||
| ||
| programme (see page 22) |
You can’t see any water | ●This is normal: the water level is below the window. | |
There’s no water | ●The water tap might be turned off. | |
●The water hose or | ||
going into the | ●Your water supply may be disrupted. | |
washing machine | ●The | |
| hose, may be clogged (see page 28) | |
There’s only a small | ●If you have paused the programme and you restart, the | |
washing machine may drain some water. | ||
amount of water | ||
●Don’t pour water in through the door. | ||
| ||
Water adds up during | ●This is normal: water is supplied automatically as the | |
washing | level lowers, and with heavy loads the water may fill up | |
repeatedly. | ||
| ||
Water drains away | ●This is normal: water often drains and refills to wash off | |
during washing | excess foam. (This is called foam detection.) | |
There’s no water |
| |
| ||
going into the | ●Before rinsing, the washing machine spins to drain water | |
washing machine | remaining from the wash. The water will fill up after that. | |
during rinse operation |
| |
Rinsing begins | ●If your laundry has collected to one side of the drum, rinsing | |
will start automatically to correct the imbalance. | ||
before the spinning | ||
●If there’s excess foam after washing, water may drain and | ||
finishes | ||
refill to wash it off. (This is called foam detection.) | ||
| ||
During the | ●This is normal. The washing machine has detected an | |
the drum stops and | ||
unbalanced load and is trying to correct it. | ||
rotates several times | ||
| ||
A foam and water | ●Although a foam and water may remain with the state of | |
remain in a door or | clothing and the amount of detergent, it does not have | |
door seal | influence on the performance of a rinse. | |
Spin starting is | ●This is normal. Although spin starting may be repeated, it is | |
repeated. | a function made to spin quietly. | |
|
| |
| ●The remaining time is estimated and corrected continually, | |
The displayed | and this can change the time displayed. The displayed time is | |
standard times, which may differ from the actual time required. | ||
remaining time | ||
●The remaining time will increase if an extra rinse and spin | ||
changes | ||
is required to correct the imbalance caused by laundry | ||
| collecting to one side of the drum. |
2009/08/05 | 11:34:10 |
|
|
|
|
|
| ||
|
|
| ||
|
|
|
|
|