Using your Extractor

For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking.

Control Panel

A- Light key

B- Decrease speed key

C- Display

D- Increase speed key

E- Timer key

Fig. 1	A	B	C	D	E

To switch the extractor light on and off

•Touch key A.

To switch on the extractor

•Touch either key B or D. The appliance will switch on at the first speed.

•To increase the speed touch key D.

•To switch the extractor off, touch and hold key B for two seconds when the extractor is working at higher speeds, or touch key B at speed one.

The intensive function

•The extractor is equipped with an intensive function which runs for ten minutes before returning to the previous selected speed. To activate the intensive function, touch key D at speed three. The display will blink whilst the intensive function is on.

The timer

•The extractor is equipped with a timer that allows the extractor to run for 15 minutes before switching off automatically.

•To activate the timer, touch key E. The display will flash a decimal point when the timer is on.

Please note

The timer cannot be activated when the intensive function is on.

The clean air function

•The extractor is equipped with a clean air function that switches on the motor for ten minutes every hour at speed one.

•To activate the clean air function, touch key E for two seconds when the appliance is off. To return to normal function, touch either key B or D. To switch off the clean air function, touch key E. The display C will light up in sections whilst the motor is running, and will show the letter C during the fifty minutes when the motor is not running.