Installation

The extractor is mounted using five screws. Ensure that the wall fixings and screws are suitable for the wall material. Mark the positions of the five holes on the wall, according to (fig 6).

Insert five wall plugs into the holes A and B (fig. 7) and fix four screws into holes A corresponding to the keyholed positions on the extractor so that they are protruding from the wall by approximately 5mm.

Next lift the hood onto the screws as shown in figure 7. At this point the extractor can be aligned level.

Secure the screws and fix the hood into position, using the fifth screw (B) to prevent any movement.

Fig. 6

Fig. 7
	83
A	A
	B
	467
A	A
	50
211
	650

Fig. 8