AEG 86741 manual Appliance is

Operating Instructions

Problem	Possible cause	Remedy
The drain pump runs		Close the water tap, remove
constantly - even when	The Aqua Control anti-flood	the mains plug and inform
the appliance is	system has been activated.	your local Service Force Cen-
switched off.		tre.
Fabric softener was not	The insert in the comparti-	Clean the detergent dis-
rinsed in, compart-	ment for conditioners is not
		penser drawer and attach the
ment æ for condition-	correctly attached or is
		conditioner insert correctly.
ers is filled with water.	blokked.
		Pay attention to the maxi-
Washing is heavily	Probably too much washing	mum load quantity (see pro-
		gramme tables). In the case
creased.	has been put in drum.
		of easy-care fabrics select
		the EASY IRON programme.
	Drain hose is kinked.	Remove the kink.
	Maximum pump height	Contact your local Service
		Force Centre. For pumping
	(emptying height 1m from
		heights over 1 m a conver-
The washing is not suf-	base surface of the appli-
		sion kit is available as a spe-
ficiently spun. Water is	ance) is exceeded.
		cial accessory.
left in the drum.
		Switch off appliance and pull
Error code (2 appears.
	Drain pump is blocked.	out the mains plug. Clean
		the drain pump.
	At the siphon connection: Si-	Clean siphon.
	phon is blocked.
	The door is locked for safety	Wait until the DOOR/LIGHT
	reasons (DOOR/LIGHT display
The door cannot be	is OFF).	display lights up green.
opened when appliance		Cancel programme security
is switched on.	The programme security
		(see section „Programme
	function is On.
		protection“).
	Water tap is not fully	Open water tap fully.
	opened.
Remnants of detergent
		Close the water tap. Unscrew
are building up in the	The inlet hose filter in the
detergent drawer.		the inlet pipe from water tap
	coupling of the inlet hose at
		and from the appliance and
	the tap is blocked.
		clean the filter.

34