Electrical connection
Details of the mains voltage, current
type and required fuses can be found on the rating plate. The rat- ing plate is located at the top above the filling door.
For permanent electrical connection within the electrical circuit, provi-
sions must be made which allow for electrical disconnection of the ap- pliance from the mains with a contact opening of at least 3 mm at all poles. Suitable devices include circuit breakers, fuses (threaded fuses must be entirely removed from the socket), ground fault circuit inter- rupters and contactors. Permanent connection may only be carried out by an authorised electrician.
5 This appliance complies with the following EC directives:
–The "Low Voltage Directive" 72/23/EU with changes
–The "EMC Directive" 89/336/EU with changes
Water connection
3 The washing machine has safety features which prevent
This means that additional protective measures in the installation are not necessary.
Important!
–Units for connecting to cold water must not be connected to hot wa- ter.
–Use only new hose sets for the connection.
Permissible water pressure
The water pressure must be at least 1 bar (= 10 N/cm2 = 0.1 Mpa), max- imum 10 bar = 100 N/cm2 = 1 Mpa).
•If more than 10 bar: Connect a
•If less than 1 bar: Unscrew the inlet hose on the unit side at the sole- noid intake valve and remove the flow regulator (to do this, remove the filter with pointed pliers and take out the rubber washer behind). Replace the filter.
59