Splendide WD2100XC manual Installation Requirements, Electrical Shock Hazard

Page 6

Installation Requirements

ATTENTION!

For your own protection and to prevent accidents, injury, and fire, please read the following carefully before installing the washer-dryer.

•Installation and grounding must be done in accordance with local codes and by a qualified installer. Installation Instructions provided in this booklet are for the installers’ reference.

•Washer-dryer MUST be installed on a strong, level floor and in a protected dry and well- ventilated area close to a power supply and drain outlet of sufficient capacity. DO NOT install on carpet.

IMPORTANT: Installation on carpet floors will cause the machine to vibrate and may result in excessive machine vibration during the spin cycles and loss of performance.

•The washer-dryer should be plugged into a properly grounded (3) prong electrical outlet capable of 120 Volt, 60 Hz, 1300 W, and 10.5 Amp. It shouldn’t be controlled by a wall switch or pull cord which could be turned off accidentally. For your safety, the third or round grounding prong must never be removed. DO NOT USE AN EXTENSION CORD.

•DO NOT install or store this appliance where it will be exposed to weather or in an area where gasoline or other flammables are stored.

!WARNING

ELECTRICAL SHOCK HAZARD

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or electrical shock.

GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction, or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment grounding conductor and grounding plug. The plug must be plugged into an appropri- ate outlet that is properly installed and grounded in accordance with all local codes and ordinances. DO NOT modify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.

WARNING! Improper connection of the equipment -grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.

6Installation requirements

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Contents 210oXCGeneral Information Technical information For Your Safety Read all instructions before using any applianceRead this manual CongratulationsIntroduction For your recordsInstallation Requirements Electrical Shock HazardDrainage ElectricalLocation Outlet End of Drain Hose provided with the unitUnpacking the washer-dryer Installing the washer-dryerConnecting the water inlets Removing the transit screwsConnecting the drain hose Floor StandpipeInstalling exhaust ducting Leveling the washer-dryerCompleting the installation Testing and cleaning the washerAbout your washer-dryer Risk of Electric Shock Do not OpenDescription of the control panel Description of the Option Buttons Description of the Program KeyLaundry Aid Type / Amounts About the Dispenser DrawerCycle Description Chart Washing and dryingSelect the wash cycle Maximum Wash Cycle capacity CottonsMaximum DRY Cycle capacity 8 to 11 lbs Select the dry timeCombine large and small items in one full Splendide laundry tipsFor best results Wash cycles are 30 to 96 minutesCombo laundry FAQ’s Sample wash-to-dry loadsSample Load Cleaning the dispenser drawer Care and maintenanceCleaning your appliance Turning off the water or electricity supplyTo access the pre-chamber Cleaning the pump pre-chamberNo lint filter to clean Checking the dryer ventTroubleshooting Unit has entered diagnostic mode and there may be a problemIf you need assistance Hours Mon-Fri 7AM-5PM PST Local Phone
Top Page Image Contents