Splendide 7100XC Electrical, Location, Drainage, Outlet End of Drain Hose provided with the unit

Electrical

•Machine Voltage/Amperage - 120V, 60 Hz, 1300 W, 10.5 Amp.

•Connection - 3-prong plug with 6’ cord is provided with the machine.

•Circuit/Protector - 3-wire single phase, 120V, 60 Hz, AC, on a separate 15 Amp circuit.

If you have...

no access to Hot/Cold water hookups

concerns about the appliance shifting in your RV or boat

water damage concerns

You’ll need...

Splendide Faucet Adapter Kit, or equivalent.

Splendide SecureFit bracket kit, or equivalent.

Splendide Drain-A-Way Pan, or equivalent.

Location

•This machine may be installed free standing as well as in a recessed area, closet, or alcove

•Minimum Installation Spacing - 0” on sides and 1” in front and back. NOTE: Additional installation spacing needs to be considered for easy installation, servicing, and compliance with state and federal codes.

•Floor - Must support at least 280 lbs. and be a solid, level surface. DO NOT install on carpet.

•RV/Marine Installations - When locating the appliance in a towable trailer or watercraft, position the machine over the axles or mid-ship where movement is at a minimum. Block the machine to prevent extreme movement.

•NO DRYER VENT - This appliance uses an internal water condenser to dry laundry. All humidity stays within the unit and is drained as water. NO heated or conditioned air is exhausted outside; NO exhaust vent is needed.

Drainage

Standpipe Diameter/Capacity - Needs a 1 ¼” minimum diameter standpipe with a minimum carry-away capacity of 7 gallons per minute.

Top of Standpipe - Must be between 25” and 34” high from the bottom of the machine.

Outlet End of Drain Hose (provided with the unit)

-Must be at least 20” above the bottom of the washer-dryer. An air break must be available at the standpipe to avoid siphoning. No more than 6” of the drain hose should be inserted into the drain pipe to prevent siphoning.

Installation requirements 7