Weber 1100 LP owner manual Continue frame assembly, Complete frame assembly

Page 11

Step 4

Continue frame assembly

You will need: caster frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. The fuel scale decal should face away as shown. Figure 3.

The leg tabs must be on the inside of the frames.

Add the washers to the bolts, insert in the holes as shown and tighten with the wrench. Figure 3.

Dimples to the inside

Fuel scale decal

Figure 3

Step 5

Complete frame assembly

You will need: partial frame assembly, two frame connectors, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench.

Hold one frame connector between the leg and wheel frame. Add the nylon washer to the bolt. Put the bolt through the frame and screw into frame connector. Tighten.

Repeat procedure with the other frame connector. Figure 4.

Figure 4

11

Image 11
Contents 1100 LP Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaCheck package contents AssemblyPage Check contents of hardware packs Assemble top frame Assemble wheelsComplete frame assembly Continue frame assemblyAdd front panel Insert castersAdd cooking box Install tank panel assembly Install manifold bracketInstall igniter Add fuel scale assemblyFill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall swing table Complete accessory installation To Extinguish LightingManual Lighting Drippings and grease CookingStorage and/or Nonuse Periodic Cleaning Cast Iron Cooking Grates Removal of the LP tank Refilling the LP tankMale fitting Regulator Collar Quick disconnect engaged Liquid Propane LP Tanks Safe handling tips for LP GasMWARNING Do not ignite burners while leak checking Annual MaintenanceMCAUTION Do not enlarge the burner ports when cleaning General MaintenanceView from behind cooking box Wing nuts Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position13-14 56-60 18-19 62-63 10-14 Parts List Page Page Final Word of Thanks
Related manuals
Manual 40 pages 49.43 Kb