Smeg WDI12C instruction manual Loading the Washing, Adding Detergent and Additiv ES

Page 18

GB

5.3 PREPARING THE WASHING

Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose washing and

alternate large items with small ones. For the first f ew times, weigh the wash loads and then rely on y our judge- ment. Av erage weights of common garments are shown below:

5.4LOADING THE WASHING

1.Open the door and load the washing taking care to distribute it unif ormly, loosely and not packed into the drum; alternate large items with small ones if possible.

2.The washer dry er described in this manual can be loaded with up to 5kg of washing. Heavier loads will lead to unsatisf actory washing results and may cause the machine to work incorrectly.

3.To save energy, wash full loads div ided by type of f abric, according to the quantities indicated in the “Programmes chart” supplied with this manual.

4.Close the door by pressing it against the body of the appliance until y ou hear a click. Make sure no gar- ments hav e got caught between the door and the rubber gasket.

Attention!

If the door is not closed properly, a saf ety dev ice prevents the washer dry er f rom working.

Do not use more than the recommended amount of detergent: too much may deteriorate washing re- sults.

5.5 ADDING DETERGENT AND ADDITIV ES

Follow the instructions shown in the “Programme Chart” provided to- gether with the manual and add detergent and any additiv es to the relativ e compartment before starting the programme.

Pour the pre-wash powder detergent into the compartment marked “1”.

Pour main wash detergent into compartment “2”. Machine accessories include a red insert “A” that can be placed inside compartment “2” to allow liquid detergent to be used. The additiv es are automatically in- troduced into the tub during f inal rinsing.

Pour liquid additives such as starch and f abric softener into “3”, marked with .

If bleach can be used with the machine (no cov er marked with ) add bleach to compartment “4” if you wish.

The level of the liquids must not exceed the maximum limit, otherwise the trays will be emptied too soon.

Bef ore pouring thick additiv es into the tray, dilute them with a little water to prev ent them f rom obstructing the trap. Only use f oam-controlled detergent suitable for use in washer dryers.

Determine the quantity of detergent according to the hardness of the water, and the type, quantity and dirtiness of the washing.

This will allow y ou to obtain the required effect using as little detergent as possible.

Detergent packs indicate the quantities to use according to 4 lev els of hardness and f or normally dirty loads of 4-5 kg.

Ask your local water board to tell you how hard y our water is.

Water hardness

 

 

 

 

 

Hardness level

French degree fH

German degree dH

 

 

 

Soft

Up to 15°

Up to 8°

 

 

 

Moderately hard

15° - 25°

8° - 14°

 

 

 

Hard

25° - 40°

14° - 22°

 

 

 

Very hard

Over 40°

Over 22°

 

18

Image 18
Contents Integrated Washer Dryer Contents NEW Washing System Safety Warnings Sibility for uses other than those described aboveProlonged inactiv ity AnceInstallation Instructions UnpackingAdditional Important Installation Instructions Water Supply ConnectionDrain Connection Electrical ConnectionFitting the Furniture Doors Use of the furniture door fixing template Fitting the hinge components to the furniture doorRecessing the appliance Fitting the plinthDescription of Controls Control PanelOpen door button ON-OFF and programme selection knob Time remaining Select the drying programmeSpin speed Error codesLED End of cycle ENDTion for heating increases Options enabled LEDs Detergent TrayWashing Instructions Preparing the WashingOpening the Door Loading the Washing Adding Detergent and Additiv ESDosing Powder Detergents Dosing Liquid DetergentsSCALE-REMOV ERS Modifying Starting Param Eters OptionsInterrupting or Changing the Washing Programme Turn the programmes knob to OFF to switch off the machineStarting the Washing Programme END of ProgrammeDrying Instructions END of Programme BeeperGeneral WASH-ONLY Programmes WASH+DRY Programmes5kg DRY-ONLY Programme ExampleInterrupting or Changing the Drying Programme END of Drying ProgrammeProgramme Finished Buzzer Cleaning the Drum Cleaning and MaintenanceExternal Cleaning Cleaning the Door GasketCleaning the Detergent Tray Cleaning the Water Inlet FilterTroubleshooting Error Signals Control Panel Symbols ProgramsSection Programme Guide KEY to Button Hemp fabrics