Smeg WDI12C Starting the Washing Programme, Interrupting or Changing the Washing Programme

Page 21

GB

5.11STARTING THE WASHING PROGRAMME

1.Bef ore starting the selected programme, carefully close the door, open the water tap and add the deter- gent and additiv e

2.Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the cy cle.

After starting, the display shows the time remaining until the end of the programme. The LED remains on throughout the cycle.

Example

If delayed starting has been set (only f or models f eaturing this option), the display visualises the time remain- ing bef ore the cycle starts. When delayed starting is set, the relativ e LED f lashes on and off.

Example

5.12 INTERRUPTING OR CHANGING THE WASHING PROGRAMME

The washing programme may be interrupted at any time while it is running:

1.press “Start/Pause” f or approximately 3 seconds: the display alternates between STOP (f or 1 second) and three horizontal lines (f or 1 second) and the Start/Pause LED f lashes.

The programme can also be stopped by turning the programme/temperature selection knob while the cy - cle is running.

2.If you wish to change the washing programme, simply select the new programme by turning the pro- gramme knob without pausing the machine f irst. The new washing cycle will be perf ormed starting from the beginning. If the tub is already full of water, the new programme will omit the filling phase.

3.To resume the cycle, press Start-Pause again.

5.13END OF PROGRAMME

The washing programmes are automatically completed, the display shows END and the “Time remaining” LED lights up.

1.Turn the programmes knob to OFF to switch off the machine.

2.Open the door.

3.Remov e the washing from the drum.

4.Leav e the door ajar in order to allow the inside of the washer dryer to dry.

5.Turn off the water tap.

If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub f ull (spin speed 0), STOP appears on the display at the end of the washing programme, alternating with 0000 (spin speed 0) and the spin LED lights up.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Integrated Washer Dryer Contents NEW Washing System Sibility for uses other than those described above Safety WarningsAnce Prolonged inactiv ityUnpacking Installation InstructionsWater Supply Connection Additional Important Installation InstructionsElectrical Connection Drain ConnectionFitting the Furniture Doors Fitting the hinge components to the furniture door Use of the furniture door fixing templateFitting the plinth Recessing the applianceDescription of Controls Control PanelOpen door button ON-OFF and programme selection knob Select the drying programme Time remainingLED Error codesSpin speed End of cycle ENDTion for heating increases Detergent Tray Options enabled LEDsWashing Instructions Preparing the WashingOpening the Door Adding Detergent and Additiv ES Loading the WashingDosing Powder Detergents Dosing Liquid DetergentsSCALE-REMOV ERS Options Modifying Starting Param EtersStarting the Washing Programme Turn the programmes knob to OFF to switch off the machineInterrupting or Changing the Washing Programme END of ProgrammeDrying Instructions END of Programme BeeperGeneral WASH-ONLY Programmes WASH+DRY Programmes5kg Example DRY-ONLY ProgrammeInterrupting or Changing the Drying Programme END of Drying ProgrammeProgramme Finished Buzzer External Cleaning Cleaning and MaintenanceCleaning the Drum Cleaning the Door GasketCleaning the Water Inlet Filter Cleaning the Detergent TrayTroubleshooting Error Signals Control Panel Symbols ProgramsSection Hemp fabrics Programme Guide KEY to Button
Top Page Image Contents