Smeg WM62141, WM62121 manual Failure Possible cause Remedy

Failure	Possible cause	Remedy
The machine does not	Machine is not powered.	Check if:
work (indicator LED’s		• power in the socket,
are not illuminated).		• the fuse is OK,
		• plug is in the socket.
Washing program	Door is not properly closed.	Push it towards the machine.
does not start
(washing stage LED is
flashing).
Water does not enter	Disturbed water inlet.	Check if:
the machine (after		• the water faucet is open,
approx. 8 min the		• inlet pipe net filter is clean.
machine reports		Push the START button.
failure -3 flashes).
Water is leaking from	Filter is not tightly screwed in.	Tighten the filter properly.
the machine.	Inlet pipe is not tightly screwed	Tighten the inlet pipe.
	to the machine or to the water	Affix the outlet pipe to the drain.
	faucet.
	Outlet pipe fell to the floor.
The machine moves	The machine is not properly	Level the machine with the adjustable
during operation.	leveled.	legs.
	Transport brackets are not	Remove transport brackets.
	removed.
The machine vibrates	Unevenly distributed laundry,	This is normal, the machine will
during the spin.	especially with very small	reduce the RPM if vibrations are too
	quantities (for ex. only the	strong.
	bathrobe).	Wash larger quantity of laundry.
Excessive foaming	Excessive measure of detergent.	Use washing powder according to
during washing.		the instructions by the producer and
		according to the water hardness and
		soiled laundry.
		Use only detergents for machine
		washing.
Water is poorly	Water outlet is clogged.	Check if:
pumped out or not at		• the filter is clean,
all (machine reports		• outlet pipe is not jammed,
failure - seven flashes		• outlet pipe is positioned higher than
of LED).		1 m.
		Push START again.
Laundry is not	The machine switched on the	The machine operates normally.
properly spun.	UKS* function. Because of bad	Wash large and small pieces of
No failure is reported.	laundry balance, the machine	laundry together.
	has automatically reduced spin		187348
	RPM.

25