Smeg STL 60 manual Adjust the feet, Connect the water inlet hose

Page 17

Adjust the feet

Install the washing machine on a level surface, near to electrical, water and drain connections.

If the floor is uneven, adjust the feet (do not insert pieces of wood, cardboard etc. under the feet):

1.Loosen the locknut using the wrench provided.

2.Adjust the height of the foot by hand.

3.Retighten the locknut by turning it anti-clockwise.

Make sure that all feet are resting correctly on the floor and that the washing machine is perfectly level and stable (use a spirit level).

The washing machine can be installed in an area 40 cm wide and 63 cm deep.

Note: if you install the machine on thick carpet, adjust the feet to ensure that there is sufficient space under the machine for the air to circulate.

Connect the water inlet hose.

1.Carefully screw the water inlet hose onto the tap by hand.

2.Make sure there are no kinks in the hose.

3.Check water-tightness of tap and washing machine connections by turning the tap completely on.

If the hose is too short, replace it with a suitable length of pressure resistant hose (minimum 1000 kPa - EN 50084 approved type).

Periodically check the hose for brittleness and cracks. Replace if necessary.

The washing machine can be connected without a non-return valve.

GB 15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents GB STL Programme Chart Intensive Rinse button Load Water Energy Approx. ProgrammeOne rinse cycle is added to ensure a more intensive rinse Half Load buttonContents Before Using the Washing Machine First Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineLoading the laundry Dosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmePump operates Water stop fault depending on modelWater Stop fault may have been triggered by Wait for the water to cool so as to avoid any accidents Before contacting After-Sales ServiceSpecify Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemDepending on model FloorValid Only For Great Britain And Ireland Fuse replacementTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A
Top Page Image Contents