Smeg STL 60 manual Loading the laundry

Page 7

Loading the laundry

1.Open the machine lid.

2.Open the drum by pressing the small flap (2a) or the push button (2b) - depending on model - and holding the large flap. For the drum opening shown on 2c, you just have to press the push button, without holding the large flap.

3.Place the items of laundry in the drum one by one without compressing them. Follow loads recommended in the “programme chart”: overloading will result in unsatisfactory washing results and creased laundry.

4.To close the drum, hold both doors in the middle again.

ATTENTION: Make sure that the drum flaps are properly locked (for model as shown on photo 2c: the button must protrude out beyond the edge of the big door flap)

GB 5

Image 7

Contents GB STL Programme Chart Half Load button Load Water Energy Approx. ProgrammeIntensive Rinse button One rinse cycle is added to ensure a more intensive rinseContents Before Using the Washing Machine First Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater Stop fault may have been triggered by Water stop fault depending on modelPump operates Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetFloor Water stop anti-flooding systemConnect the water drain hose Depending on modelPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland To fit a new plug, proceed as follows