Smeg STL 60 manual Valid Only For Great Britain And Ireland, Fuse replacement

Page 19

ELECTRICAL CONNECTION

Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations.

1) Warning - this appliance must be earthed

This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity.

If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.

Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket.

2)CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician

The wires in the mains lead are coloured in accordance with the following code:

BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”)

GREEN AND YELLOW - “EARTH” (“E”)

Valid Only For Great Britain And Ireland

To fit a new plug, proceed as follows:

2.1Polarized Plugs (e.g. 3 pin, 13 amp plug conforming to BS 1363A)

a.The GREEN AND YELLOW wire must be connected

to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured green and yellow.

b.The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured blue.

c.The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured brown.

2.2Non-polarized plugs (e.g. 2 pin with side earth contact). The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour.

Fuse replacement

If the mains lead of this appliance is fitted with a

BS 1363A 13amp fused plug, replace the fuse only with an A.S.T.A. approved type conforming to BS 1362 and proceed as follows:

1.Remove the fuse cover (A) and fuse (B).

2.Fit the replacement 13 A fuse into the fuse cover.

3.Refit both into plug.

GB 17

Page 18 Page 19
Image 19
Page 18 Page 19
Contents GB STL Programme Chart Half Load button Load Water Energy Approx. ProgrammeIntensive Rinse button One rinse cycle is added to ensure a more intensive rinseContents Before Using the Washing Machine First Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater Stop fault may have been triggered by Water stop fault depending on modelPump operates Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetFloor Water stop anti-flooding systemConnect the water drain hose Depending on modelPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland To fit a new plug, proceed as follows
Top Page Image Contents