Water connections
a) Water inlet hose
The specific hoses that come with the machine are connected to the water inlet valves on the machine. Red labeled hose is for hot water inlet and blue labeled hose is for cold water inlet.
In order to prevent the water leakages that may occur on the connection points, rub- ber seals are placed on the hose or in the package (4 pieces for the models with double water inlets and 2 pieces for other models). These gaskets should be used for connections in both sides of the hose. Gaskets on the machine side should fit in the hose filter channel.
Since the connection points are under water pressure, turn on the taps to the maximum after the connection. Check if there is any water leakage at the connec- tion points. In order to prevent the water leakages and the damages they may cause, keep the taps closed when you are not using the machine.
Minimum 1 bar and maximum 10 bars of water flow from the tap is enough for your machine to operate efficiently. (In practice, 1 bar means that more than 8 liters of wa- ter per minute flows from a full open tap.)
Install the elbowed end of the hose to your machine.
Models with double water inlets can be used as a model with a single water inlet by using a plug. Plug should be installed to the hot water valve. A rubber gasket should be used in order to prevent water leakage from the connection point.
Do not connect the product with single wa- ter inlet to the hot water tap. The product may switch to the protection mode if the temperature of the water connected to a product with double water inlet through a Y part and single water inlet is above 40°C.
a) Water drainage hose
Water drainage hose can be attached to the side wall of a sink or bathtub. Hose should not be bend. When the drainage hose is hanged on a sink or bathtub, it can be secured with a hose bracket so that it will not fall.
The end of drainage hose can be connected directly to the waste water drainage hole or to the specific end that is installed to the outlet elbow of the sink.
The hose should be installed to a height of 40 cm minimum and 100 cm maximum.
7