Smeg GB ST L80 manual Before contacting After-Sales Service, Specify

Page 15

AFTER-SALES SERVICE

Before contacting After-Sales Service:

1.Try to remedy the problem yourself (see “Troubleshooting Guide”).

2.Restart the programme to check whether the problem has solved itself.

3.If the machine continues to function incorrectly, call After-Sales Service.

Specify:

•The nature of the problem.

•The exact model of the washing machine.

•The service code (number after the word SERVICE).

The After-Sales Service sticker is in the lid of the foreign body trap or on the rear of the machine.

• Your full address.

• Your telephone number and area code.

As a priority, you should contact the After-Sales Service of the retailer who supplied you with the washing machine.

TRANSPORT AND HANDLING

1.Unplug the washing machine.

2.Turn off the tap.

3.Remove the water supply and drain hose.

4.Eliminate all water from the hoses and the washing machine (see “Draining residual water”).

Wait for the water to cool so as to avoid any accidents.

5.To facilitate moving the machine, pull the handle situated at the bottom front (optional on certain models) out a little by hand and pull it out to the stop with the foot.

Afterwards push the handle back into the original stable position.

6.Fix the transport bracket again for transportation.

7.Transport the washing machine upright.

IMPORTANT: Do not use the washing machine while the handle is pulled out.

GB 13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents GB STL Programme Chart Half Load button Load Water Energy Approx. ProgrammeIntensive Rinse button One rinse cycle is added to ensure a more intensive rinseContents Before Using the Washing Machine First Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater stop fault depending on model Water Stop fault may have been triggered byPump operates Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetFloor Water stop anti-flooding systemConnect the water drain hose Depending on modelPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland To fit a new plug, proceed as follows
Top Page Image Contents