Smeg GB ST L80 manual Programme Selection

Page 9

PROGRAMME SELECTION

Preparation of wash cycle

1.Load the machine, close the drum flaps and check that they are properly locked.

2.Add detergents and additives into the dispenser to no more than the “MAX” level mark. Please refer to “Detergents and additives”.

3.Turn the programme selector knob to the desired programme.

4.Turn the temperature selector knob (if available) to the desired temperature.

5.Turn the spin speed selector knob (if available) to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not intermediate spins. The programme ends with a drain cycle.

6.Select the desired options as described in the Programme Chart.

Programme start

Switch on the washing machine- the indicator lights up.

Note: If there is a power interruption or if the washing machine is disconnected during the cycle, the programme will run again from the point where it was interrupted.

End of wash cycle

The programme selector knob is in the Stop position.

1.Switch off the washing machine.

2.Cancel the options.

3.Turn the tap off.

4.Wait for the lid to unlock (about 1 minute).

5.Open the lid and the drum flaps and unload the machine.

Change the programme during the wash cycle

1.Switch off the washing machine.

2.Select the new programme.

3.Start the programme by switching on the machine.

Pause/Interrupt a programme

If for any reason you wish to interrupt the programme for a certain time and continue it later:

1.Switch off the machine.

2.After the desired pause turn on the machine again.

Cancel programme

1.Switch off the washing machine.

2.Set the programme selector to “Drain”.

3.Switch on the machine again to start the “Drain” programme.

GB 7

Image 9
Contents GB STL Programme Chart Intensive Rinse button Load Water Energy Approx. ProgrammeOne rinse cycle is added to ensure a more intensive rinse Half Load buttonContents Before Using the Washing Machine First Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineLoading the laundry Dosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byPump operates Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemDepending on model FloorValid Only For Great Britain And Ireland Fuse replacementTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A