Smeg K600TL1 manual Rinse Hold button, Appliance in Rinse Hold, No Spin button, Half Load button

Page 20

CONSUMPTION DATA

 

Temperature

Load

Water

Energy

Approx. Programme

Programme

selector

 

 

 

Duration

 

 

 

 

 

 

(°C)

(kg)

(l)

(kWh)

(hours : minutes)

Cotton

95

5,0

63*

1,80

2:05

Cotton

60

5,0

55

0,95

2:05

Cotton

40

5,0

55

0,55

2:05

Synthetic

60

2,0

56

0,80

1:30

Synthetic

40

2,0

56

0,40

1:30

Delicate

40

1,5

60

0,55

0:45

Wool

40

1,0

60

0,50

0:40

Silk

30

1,0

60

0,30

0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

*To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

“Rinse Hold” button

•The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

•This option is particularly recomended for the “Synthetic” and “Delicate” programmes.

•This function is particularly useful if you want to postpone spinning to a later time, or if you want to

drain only.

Note: the programme selector knob stops on .

Appliance in “Rinse Hold”:

•Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.

•If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again.

PROGRAMME START

Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1.Switch off the machine by pressing the “On/Off” button.

2.Select the new programme.

3.Start programme by pressing the “On/Off” button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1.Press the “On/Off” button.

2.After the desired pause, press again the “On/Off” button.

CANCEL PROGRAMME

1.Switch off the machine by pressing the “On/Off” button.

2.Set the programme selector to “Drain”.

3.Press the “On/Off” button again to start the “Drain” programme.

PREPARATION OF WASH CYCLE

1.Load the machine, close the drum doors and check that they are properly locked.

2.Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softener and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3.Turn the programme selector knob to the desired programme.

4.Turn the temperature selector knob to the desired temperature.

SELECT THE DESIRED OPTION

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“No Spin” button

•Especially for delicate garments to avoid wear and

tear caused by the spin.

Note: with the “Cotton” and “Synthetics” programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results.

“Half Load” button

•Can be used for small loads and lightly soiled laundry.

•Reduces the water consumption especially during the rinses.

“Intensive Rinse” button

•The amount of water is increased to ensure a more intensive rinse.

•This option is particularly suitable for areas with very soft water or washing linen laundry for people with skin allergies.

is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

•The programme selector knob is in the Stop position.

1.Press the “On/Off” button to switch off the machine.

2.Cancel the options.

3.Turn the tap off.

4.Wait for the lid to unlock (about 1 minute).

5.Open the lid and the drum doors and unload the machine.

5019 612 10083

Page 19 Page 20
Image 20
Page 19 Page 20
Contents Contents Before Using the Washing Machine Install the washing machineRemove the packaging and check Electrical connection Remove the transport bracketPrecautions and General Recommendations First Wash CycleSort the laundry Description of the Washing MachinePreparation of the Washing Starching Stain removalDyeing and bleaching Loading the laundry Open the machine lidFilling up with detergents and additives Detergents and AdditivesDosage Programme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenserCheck and clean regularly at least two or three times a year Water inlet hose filterWater inlet hoses Washing machine does not start, no lamp lights upWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byBefore contacting After-Sales Service SpecifyRemoval of transport bracket Adjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hosePolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland GB K 600 TL1 Rinse Hold button Appliance in Rinse HoldNo Spin button Half Load button

K600TL1 specifications

The Smeg K600TL1 represents a perfect blend of style, innovation, and functionality in the realm of kitchen appliances. Known for their aesthetically pleasing designs and robust performance, Smeg has once again delivered a product that caters to both modern living and traditional values.

One of the standout features of the K600TL1 is its impressive cooling capacity, making it an ideal choice for households that require ample storage for fresh and frozen foods. The appliance boasts a generous capacity, allowing users to store a wide variety of groceries while keeping them organized and easy to access.

Equipped with advanced cooling technologies, the K600TL1 ensures optimal performance and energy efficiency. The MultiFlow cooling system evenly distributes cold air throughout the refrigerator, eliminating hotspots and maintaining a consistent temperature. This feature not only preserves the freshness of food for longer but also reduces energy consumption, making it an environmentally friendly choice.

Another innovative technology incorporated in this model is the No Frost system. This greatly reduces the need for manual defrosting, as it actively prevents the build-up of ice, ensuring the freezer remains unclogged and fully functional. Users can enjoy hassle-free maintenance and spend less time cleaning and more time enjoying their meals.

The Smeg K600TL1 also includes adjustable shelving and door bins, providing customizable storage options. This flexibility allows users to arrange the refrigerator compartments according to their personal needs, maximizing both space and convenience. Furthermore, the LED lighting enhances visibility within the fridge, making it easier to find ingredients at any time.

Safety and hygiene are also prioritized with this appliance. The antibacterial treatment on the inner walls helps inhibit the growth of harmful bacteria, contributing to a cleaner and healthier environment for food storage.

With its sleek stainless steel finish and chic design, the Smeg K600TL1 not only enhances kitchen aesthetics but also serves as a statement piece in any home. Overall, the Smeg K600TL1 is an ideal combination of style, efficiency, and innovative technology, making it a top contender for those looking to upgrade their kitchen appliances.
Top Page Image Contents