Things to do Before Calling the Authorized Service
If the light of the 1st auxiliary function | It is in the | |
on the left hand side is flashing | ||
| ||
|
| |
If the cover and washing light on the | The program selection knob may be | |
position. | ||
program | ||
Readjust the program by turning the program | ||
flashing and the end light is | ||
selection knob. If the warning continues, contact the | ||
constantly on | ||
authorized service. | ||
| ||
If the light of Start/Pause/Cancel | The door may not be properly closed. Open and | |
button starts to flashing after a short | close the door again and restart the washing pro- | |
time you start your machine | gram. | |
| The water may be cut or the taps may be closed. | |
If the “Washing” light on the program | Check the taps. Turn off your machine and restart. | |
If the fault persists, unplug your machine, close the | ||
| taps and contact the authorized service. | |
| Machine may be in the | |
| substructure problems (grid voltage, water pressure and | |
If the program can not be started or | etc.) | |
Therefore, you can not start or select a program. Press | ||
selected | ||
Start/Pause/Cancel button for 3 seconds and return | ||
| ||
| the machine to the factory settings. (See.Cancelling a | |
| Program) | |
If the water is cut while your machine | Press “Start/Pause/Cancel” button, program will | |
is operating, the current program does | ||
not proceed. To continue the program | proceed. | |
Your machine may stop due to the low | Wait for a while. When the voltage reaches to a nor- | |
voltage | mal level your machine will start to operate. | |
During the production, some water |
| |
may have remained in your machine | This does not cause any damage to your machine. | |
because of the quality control | ||
| ||
processes. |
| |
You have selected the program in your | The plug of your machine may not be plugged in a | |
machine and pressed the “Start/ | grounded outlet, front cover may not be closed or | |
Pause/Cancel” button but the machine | ||
the fuse may be blown. | ||
did not start |
| |
| Check the water inlet and drainage hoses. Are they | |
Is water coming from under your | well mounted? Gaskets of the water inlet hoses may | |
machine | not be well seated. If the problem is none of them, | |
| the pump filter may not be well closed. | |
Is the water drained directly? | Check if the drainage hose is connected as | |
described in the user guide. | ||
| ||
During the water drainage, you may | This sound is normal. | |
hear water sound from the pump | ||
| ||
Is foam running over the detergent | Check if your detergent is suitable for automatic | |
machine. Use the recommended amount of | ||
drawer? | ||
detergent in your next washing. | ||
| ||
If sometimes you are not satisfied with | Make sure that you have selected the correct | |
the rinsing and spinning | program, you have adjusted the speed adjusting/ | |
efficiency (laundries have | decrease button correctly and you have loaded the | |
detergent remnants or they are not dry | right laundries for the program you have chosen, try | |
enough)? | again when the voltage is normal. |
6
EN