Beko 2012 CX, 2112 CX manual Maintenance and cleaning

Page 14

Maintenance and cleaning

Detergent Drawer

The powder detergent remnants may accumulate in the detergent drawer. To clean the detergent drawer, pull the drawer towards you by pressing the marked point of the siphon in the softener compartment as shown in the illustration. Wash the drawer in the sink with plenty of water.

be cleaned when they get dirty. To do this, close the taps. Remove the water inlet hoses. Clean the tops of the filters on the water inlet valves with a thin brush. If the filters are very dirty, you can pull out with pliers and clean them. The filters on the flat end of the water inlet hoses should be taken out with their gaskets by hand and cleaned thoroughly under the flowing water. (There are 2 filters in the machines with single (cold) water inlet and 4 filters in the machines with double (hot-cold) water inlets.

Siphon

Do not forget to clean the siphon

(the colored part in the detergent drawer) when it gets dirty. To remove the siphon, first take out the detergent drawer. To prevent clogging, clean the softener remnants inside of it. After cleaning, put back the siphon and check if it is well seated or not.

Inlet Water Filters

At the end of the water inlet valves which are mounted to the back of the machine and the flat end of the water inlet hoses that are mounted onto the taps, there is one filter for each. These filters prevent the foreign substances and dirt in the

water entering the machine. Filters should

Hose

Since there is a risk of freezing especially in the cold areas, the water remaining in the appliance can frozen and damage the appliance. In this case, the water remain- ing in the pump and hoses should be drained by removing the pump filter. Water inlet hoses should also be emptied by removing them from the taps.

Cleaning the pump filter

Clean the foreign substance filter periodically at least for once!

If the foreign substances (coins, buttons, baby socks and etc.) clog the foamy water pump, clean the filter.

Before cleaning, empty the water that remains inside first.

Hot water danger: There may be 15 liters of hot water at 90°C in the machine. Open the filter carefully.

Drain the water completely in the following

14

EN

Image 14
Contents 2012 CX Contents Your Washing Machine Specifications of your Washing Machine Main water pressure should be between Bars Things to do Before Calling the Authorized Service Taps and contact the authorized serviceAdjusting the feet InstallationRemoving the transportation safety bolts Removing the packaging rein- forcementsWater connections Preparation Electrical ConnectionProgram Selection and Operating Your Machine Turning On/OffProgram selection table Rinsing Rinsing Program Spin+Pump Spin + Pump ProgramChild Lock Function SelectionAuxiliary Functions Program FlowLaundry Addition Function Cancelling a programChanging the Program End of the ProgramMaintenance and cleaning Situations Before cleaning the foreign substance filter