Tube Screen Appearance
Light and dark spots caused |
|
by image converter tube may |
|
be visible in the field of view. | . . |
These are normal and not considered |
|
imperfections by Image Intensifier |
|
Standards. Most of the distortion |
|
will occur in the peripheral area, |
|
not in the center. |
|
Maintenance
1.Always clean lens with professional supplies. Never wipe dirt or dust off the lens. You may use dry, compressed air.
2.Clean the housing with a dry, soft cloth.
3.Store in a dry, well ventilated area. Never store near a heater, air conditioner, or in direct sunlight.
4.Remove battery when storing for more than two weeks.
Troubleshooting
1.The screen will not glow while in the on position: Check battery. Make sure it is charged and installed properly.
2.The image fades or disappears completely: If you are in complete darkness, the scope needs some light. Activate the Illuminator (#6). It is possible that you pointed the device at an intense light source which might have shut down the unit to protect the intensifier tube. Turn the power off and wait five minutes before turning it back on.
3.Unable to properly focus: Try adjusting the focus on both the Eyepiece (#1) and the
Objective Lens Ring (#4) Also, try cleaning the lens with professional supplies.
# 47894 | REV 01/03 | 4 |
