Snapper 2300 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | |||
| 1. | Nozzle in low pressure mode. | 1. | Pull nozzle backward for high pressure | |
|
|
|
| mode. | |
Pump has following | 2. | Water inlet is blocked. | 2. | Clear inlet. | |
3. | Inadequate water supply. | 3. | Provide adequate water flow. | ||
problems: failure to | 4. | Inlet hose is kinked or leaking. | 4. | Straighten inlet hose, patch leak. | |
produce pressure, erratic | 5. | Clogged inlet hose strainer. | 5. | Check and clean inlet hose strainer. | |
pressure, chattering, loss | 6. | Water supply is over 100°F. | 6. | Provide cooler water supply. | |
of pressure, low water | 7. | High pressure hose is blocked or | 7. | Clear blocks in outlet hose. | |
volume. |
| leaks. |
|
| |
| 8. | Gun leaks. | 8. | Replace gun. | |
| 9. | Nozzle is obstructed. | 9. | Clean nozzle. | |
| 10. | Pump is faulty. | 10. | Contact Snapper service facility. | |
| 1. | Detergent siphoning tube is not | 1. | Insert detergent siphoning tube into | |
|
| submerged. |
| detergent. | |
Detergent fails to mix | 2. | Chemical filter is clogged or cracked. | 2. | Clean or replace filter/detergent | |
|
|
| siphoning tube. | ||
with spray. |
|
|
| ||
3. | Dirty | 3. | See “Check | ||
| |||||
| 4. | Nozzle is in high pressure mode. | 4. | Push nozzle forward for low pressure | |
|
|
|
| mode. | |
Engine runs good at no- | Engine speed is too slow. | Move throttle control to FAST position. If | |||
load but “bogs” when |
|
| engine still “bogs down”, contact Briggs and | ||
load is added. |
|
| Stratton service facility. | ||
Pressure washer shuts | Out of gasoline. | Fill fuel tank. | |||
down during operation. |
|
|
|
| |
15
