Snapper 2300 PSI Pressure Washer
Figure 3 — Attach “L” Hooks to Handle
Spray Gun
Hook
Hose Hook
4.Insert the other “L” hook through the hole just above the billboard on the right side of the handle (viewing from rear of unit). Hold the hook in place with a pliers and attach the locknut with a 7/16” wrench (Figure 3).
Add Fuel
WARNING! NEVER fill fuel tank indoors. NEVER fill fuel tank when engine is running or hot.Allow unit to cool for two minutes before refueling. DO NOT light a cigarette or smoke when filling the fuel tank.
WARNING! DO NOT overfill the fuel tank. Always allow room for fuel expansion.
•Place pressure washer on a level surface.
•Refer to engine owners manual to add recommended fuel to engine.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure.
•Place pressure washer on a level surface.
•Refer to engine owners manual to add recommended oil to engine.
NOTE: Check Oil Often During Engine
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
•Uncoil the high pressure hose and attach one end of the hose to the base of the spray gun (Figure 3).Tighten by hand.
Figure 3 — Connect High Pressure Hose to Spray Gun
Connect high |
pressure hose here |
6
