John Lewis JLWD 1609 Load the laundry, Measure out the detergent, Switch the machine on

Page 17

Using the washing machine

Before the first wash, we recommend that you run a cotton cycle at 90°C or 95°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub.

Pour 1/2 a measure of detergent into the dispenser drawer and start the machine.

WASHING

1.Load the laundry

Open the door.

Place the laundry in the drum, one item at a time, shaking them out as much as possible.

Close the door.

P0004

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure out the amount of detergent required and pour it into

the main wash compartment .

If you wish to carry out the prewash, pour detergent

into the appropriate compartment marked .

3.Measure out the fabric softener

If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.

4. Switch the machine on

Turn the selector dial to the the desired position to switch the machine on. To switch the appliance off turn it to Off.

14 Minute wash

Off

95°

45 Minute wash

 

Economy 60°

Spin

 

60°

Drain

 

Economy 40°

Rinses

 

40°

30°

 

30°

40°

 

Drying

Delicates 30°

 

60°

Delicates 40°

 

40°

 

 

Easy iron 40°

 

 

Drying

5.Select the desired programme/temperature

The display will show the duration of the selected programme, calculated on the basis of the maximum load for each type of fabric. The Start/Pause button light will start flashing.

If the load of laundry to be washed is small, at the beginning of the cycle the display will still indicate the duration relevant to the maximum load. The duration value will be gradually adjusted during the cycle.

2.05

SM002

SM002

SM003

6.Select the spin speed or the Rinse hold option

Press the “Spin” button repeatedly in order to select the desired spin speed or the Rinse hold option. If you select this option, the last rinse water is not emptied out.

Close the drawer gently.

17

Image 17
Contents Jlwd Spin washer-dryer Use InstallationChild Safety Service Maintenance and cleaningEcological hints Environmental informationContents Description of the appliance Child safety featureDetergent dispenser drawer Prewash Main wash Fabric softenerTechnical specifications InstallationWashing DryingInstall the machine on a flat hard floor Installation on a suspended floorUnpacking PositioningWater inlet PlumbingWater drainage Appliance must be connected to a cold water supplyOnto a sink outlet spigot If necessary, check the setting with a spirit levelLevelling Interest of the environment Blue- Neutral Brown- Live Electrical connectionPermanent connection Detergent dispenser drawer Programme selector dial Control panelSpin button Position Rinse holdAutomatic Dry button Delay start buttonTime dry button OptionsStand-by Display Programme timeSelection of drying time in minutes 105Buzzer Programme informationChild lock Load the laundry Switch the machine onMeasure out the detergent Select the spin speed or the Rinse hold optionHow to change an option or a programme during its cycle Select the Delay startHow to interrupt a programme Select the desired optionsAfter some minutes, you can open the door End of programmePress the Start/Pause button to start the programme DryingBe immediately opened Select the drying time or dryness degreeBath robe 1000g = 1 kgSheet Important notes Wash care symbolsWashing programmes Programme Consumptions Off ResetEnergy Water Description KWh RinsesDrying programmes Maintenance and cleaning Cleaning the water inlet filter Emergency emptying out Something not working Machine vibrates when Display shows the alarmSpinning Door will not open0870 01 Reparirs After sales service21/08 132 963