Drying, Be immediately opened | John Lewis JLWD 1609 manual

Drying

DRYING ONLY

The recommended load to dry in your washer-dryer is 3.5 kg for cotton and 2 kg for synthetics.

Note! Only with the timed drying, it is possible also to dry up to 4 kg of cotton items (see the drying programmes).

The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe.

1.Load the laundry.

2.Turn the programme selector dial to the «Drying» programme in the Cottons or Synthetics section.

3.If you wish to carry out the electronic drying, press Automatic dry button until the light of the desired dryness degree illuminates.

Extra dry

Cupboard dry

Iron dry

Automatic dry

If you want a timed drying, press the “Time dry” button until the time you want appears on the display (see page 14).

0.60

Time dry

4.Press the Start/Pause button to start the programme.

5.At the end of the programme, the buzzer sounds. A flashing zero «0» will appear on the display. At this point, begins an «anti-crease phase», which lasts about 10 minutes. The door can be opened only at the end of this phase.

Attention!

If you wish to open the door before the anti- crease phase or to interrupt it, press any key or turn the programme selector dial to any programme position (except Off), the door can

be immediately opened.

6.Turn the programme selector dial to Off to switch the machine off and remove the laundry.

Note:

The programme time will automatically increase by up to 2 minutes, this is quite normal.

AUTODRYING

For NON-STOP programmes, the recommended load size to wash and dry is 3,5 kg for cotton and 2 kg for synthetics.

Note! Only with the timed drying, it is possible also to dry up to 4 kg of cotton items (see the drying programmes).

Do not use a dosing device/ball when carrying out a washing & drying programme.

1.Load the laundry.

2.Add detergent and fabric softener.

3.Switch the machine on by turning the selector dial to the wash programme/fabric and temperature in the Cotton or Synthetics section.

4.Select the drying time or dryness degree.

5.Select the required options by pressing the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid too long a drying time therefore saving energy. The reduction of the spin speed is only possible after selecting drying. The lowest values you can select is 1200 r.p.m. for Cottons and 800 r.p.m. for Synthetics with Timed Drying.

6.Start the programme by pressing the Start/Pause button.

7.At the end of the programme, the buzzer sounds. A flashing zero «0» appears on the display. At this point of the programme, starts an anti-crease phase which lasts about 10 minutes. During this time the door is locked and the display keeps showing the flashing zero.

(If you wish to open the door before or during the anti-crease phase, please follow the instructions given in the previous chapter).

9.Turn the programme selector dial to Off to switch the machine off and remove the laundry.