John Lewis JLWD 1609 Machine vibrates when, Spinning, Door will not open, Machine does not spin

Page 30

Symptom

Possible causes

 

 

 

 

 

The machine vibrates when

The internal packing has not been removed.

 

spinning

The machine is in contact with the wall or furniture.

 

 

The machine is not level and stable (check diagonally).

 

 

The washing load is badly distributed in the drum.

 

 

Maybe there is very little laundry in the drum.

 

 

 

 

 

The door will not open

The water level is above the bottom edge of the door.

 

 

The machine is heating the water.

 

 

The drum is turning.

 

 

In any case the door can be opened only when the «Door lock»

 

 

light has gone out.

 

 

 

 

 

Spinning starts late or the

The electronic balance control device has cut in because the laundry is

 

machine does not spin

 

not evenly distributed in the drum. The laundry is redistributed by

 

 

 

reverse rotation of the drum. This may happen several times before

 

 

 

the unbalance disappears and normal spinning can resume. If, after few

 

 

 

minutes, the laundry is still not evenly distributed in the drum, the

 

 

 

machine will not spin. In this case, redistribute the load manually and

 

 

 

select the spin programme.

 

 

 

 

 

The machine makes an unusual

The machine is fitted with a type of motor which makes a different

 

noise

 

noise compared with other traditional motors. This new motor

 

 

 

ensures a softer start and more even distribution of the laundry in the

 

 

 

drum when spinning, as well as increased stability of the machine.

 

 

 

 

 

No water is visible in the drum

Machines based on modern technology operate very economically

 

 

 

using very little water without affecting performance.

 

 

 

 

 

The machine does not dry or

The drying time or degree of drying has not been selected

 

does not dry properly

The water tap is not turned on (E10)

 

 

The drain filter is clogged (E20)

 

 

The machine is overloaded

 

 

The selected drying time or dryness degree was not suitable for the

 

 

 

laundry.

 

 

 

 

 

The display shows the alarm

The anti-flooding system has activated. Disconnect the appliance and

 

code EF0:

 

contact the Service Force Centre

 

 

 

 

 

30

Image 30
Contents Jlwd Spin washer-dryer Installation Child SafetyUse Ecological hints Maintenance and cleaningService Environmental informationContents Detergent dispenser drawer Child safety featureDescription of the appliance Prewash Main wash Fabric softenerWashing InstallationTechnical specifications DryingUnpacking Installation on a suspended floorInstall the machine on a flat hard floor PositioningWater drainage PlumbingWater inlet Appliance must be connected to a cold water supplyIf necessary, check the setting with a spirit level LevellingOnto a sink outlet spigot Interest of the environment Electrical connection Permanent connectionBlue- Neutral Brown- Live Spin button Control panelDetergent dispenser drawer Programme selector dial Position Rinse holdTime dry button Delay start buttonAutomatic Dry button OptionsDisplay Programme time Stand-by105 Selection of drying time in minutesProgramme information Child lockBuzzer Measure out the detergent Switch the machine onLoad the laundry Select the spin speed or the Rinse hold optionHow to interrupt a programme Select the Delay startHow to change an option or a programme during its cycle Select the desired optionsEnd of programme After some minutes, you can open the doorBe immediately opened DryingPress the Start/Pause button to start the programme Select the drying time or dryness degree1000g = 1 kg SheetBath robe Wash care symbols Important notesWashing programmes Energy Water Description KWh Off ResetProgramme Consumptions RinsesDrying programmes Maintenance and cleaning Cleaning the water inlet filter Emergency emptying out Something not working Spinning Display shows the alarmMachine vibrates when Door will not openReparirs After sales service 0870 01132 963 21/08