Goodmans GDB20TTS Problems installing the channels, How to turn the set-top box off

First time installation

be shown. This is usually BBC1. An information banner will appear along the top of the picture for a short time which gives basic details of the TV programme you are watching.

Problems installing the channels

If you could not receive any channels as described previously, do the following.

•Check all the connections to your set-top box and TV making sure the connections are secure and connected to the correct sockets.

•Try the installation again by following the ‘Retuning procedure’ given on page 30.

How to turn the set-top box off

If you watch TV regularly, you should leave the set-top box in standby mode when you are not watching TV. You should only switch it off at the mains if you are away or do not want to use the TV for a long time, one month for example.

Your set-top box will automatically update the stored channels while it is standby mode as they become available. It can also receive updates to the operating software during this time. It cannot receive new channels and software updates when the set-top box is disconnected from the mains supply or the aerial is disconnected.

If you plan to disconnect the set-top box from the mains, you should put it into standby first.

You can put the set-top box on standby as follows.

1Press the button labelled stb.

2The front panel power indicator will change colour from green to red.

3The set-top box is now in standby mode.

4The set-top box ‘Scart’ output will now be turned off.

5The TV picture will be turned off.

How to turn the set-top box on from standby

1Press the button labelled stb.

2The front panel power indicator will change colour from red to green.

3This will turn on the set-top box Scart output.

4The TV picture will turn on and show the station that you were watching when the

set-top box was put on standby. 15

Goodmans GDB20TTS_Instruction Manual.indb 15

6/15/2010 4:26:30 PM