Setting time delay, Starting the programme

Setting time delay

3With the DELAY START button, you can delay the start of a programme by between 30 minutes (30' and a maximum of 23 hours (23h).

1.Select the programme

2.Press the DELAY START button as many times as neces- sary until the required start delay appears on the multi display, e.g. 12h if the programme is to be started in 12 hours. The DELAY START display is illuminated.

3If 23h is displayed and you press the button again, the time delay will be cancelled. The display will show 0' and then the duration of the selected pro- gramme.

3.To activate the delay timer, press the START/PAUSE but- ton. The amount of time remaining until the programme

is set to start is continuously displayed (e.g. 12h, 11h, 10h, … 30' etc).

3Until the start of the programme the drum is moved at longish intervals to loosen the laundry.

Starting the programme

Press the START/PAUSE button. The programme is started. The programme progress display and the display showing the level of dryness show drying progress.

Changing programme

To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF and then reset the programme.

3The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the ALARM button) is pressed, Err appears in the multidisplay. The drying pro- gramme is not however affected by this (laundry pro- tection).

Removing laundry or loading laundry when necessary

1.Open loading door

1 Warning! Laundry and drum can become hot. Risk of burns!

2.Load or remove laundry items.

3.Close the door securely. Lock must audibly lock.

4.Press the START/PAUSE button to continue the drying cy- cle.

Drying cycle complete / remov- ing laundry

Once the drying cycle is complete, the END and CREASE GUARD indicators light up. If the ALARM button has been pressed, an acoustic signal sounds intermittently.

3The drying cycles (except for the WOOL pro- gramme) are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum ro- tates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming.) If ANTI-CREASE has been selected, the anti-crease phase is lengthened by 60 minutes.

1.Open door.

2.Before removing the laundry, remove fluff from the micro- fine filter. It is best to use a damp hand for this purpose. (See “Cleaning and maintenance” section.)

3.Remove laundry.

4.Turn the programme selector to OFF.

Important: After each drying cycle

–Clean the micro-fine filter and fine filter

–Drain the condensed water container (See section “Cleaning and maintenance”.)

5.Close door.