Alternate exhaust methods
To remove the power supply cord -
Disconnect power supply.
7
When local codes.. .
A n
The washer/dryer mstallad in a mobile home must be exhausted JutsIde. When the dryer IS exhausted through the floor, the :xhaust system must termmate Jutside the enclosed area under noblIe home. Extension beyond the enclosure will prevent lint and noisture buildup under the mobile Tome. See Figure 3.
Mobile home installation
Alternate electrical connection
Electrical ground is required on this appliance.
This appliance is manufactured with the neutral terminal connected to the frame.
To connect a separate grounding wire -
Use grounding wire and clamp assembly (Part No. 665463) or No. 10 gauge minimum copper grounding wire. Connect grounding wire to a grounded cold water pipe’ with the clamp and then to the external grounding connector on washer/dryer. Do not ground to
a gas sup$y pipe. Do not connect the Dower SUDDIVcord to electric power supplj ;itil appliance Is permanently grounded.
No. A
Figure 4
Grounded cold water pipe must have metal continuity to electrical ground and not be Interrupted by plastic, rubber or other electrlcal Insulating connectors such as hoses, finings, washer or gaskets (including water meter or pump). Any electrical insulating connector should be jumped as shown In Figure 4 with a length of No. 4 wire securely clamped to bare metal at both ends.
4NEL F
1, Remove the terminal block cover from the dryer.
2.Disconnect the power supply cord from the termmal block.
3.Use a screwdnver to slide the strain rehe( clip away from the power supply cord. (See Figure 5)
4.Pull downward on the power supply cord until it IS removed from the dryer.
away trdm
Figure 5 power supply cord.
Pull out power supply cord.
Toconnect
Plain wire ends -
I. Strip outer covering back 3 inches irom the end exposing the 3 wires.
2.Strip the insulation back 1 inch from the end of each wire. Form the Dare wire into a “U”shaped hook.
3.Loosen, do not remove, screws from terminal block. Attach wires according to instrucflons for type of :onnection needed.
1.Slide the end of each wire under the screw head with the ooen &de si the hook on the right.. Sbueeze the wire together to form a loop.
5. Tighten each screw firmly.
Figure 6
To use non-metallic sheathed copper power suppfy cabfe -
CAUTION: If
Figure 7
Permit use 01flexible type power supply cord (pigtail) that comes equipped with the washer/dryer but
Do Not Permit connecting the frame grounding conductor to the neutral wire of the power supply cord:
1.Remove terminal block cover.
2.Remove the grounding wire (green) from the internal grounding connector and fasten under center
3.Connect a separate copper grounding wire (No. 10 minimum). See “Toconnect a separate grounding wire:’ Panel F for detallec instructlone
4.Replace terminal block cover.