KitchenAid Washer/Dryer Numbers correspond, Shlpplng Strap with key, Panel C

Page 4

Remove the 2 rear corner pieces attached to the back of washer/ dryer: Do not remove the foam shipping pieces between the washer and dryer until unit is in place.

Move foam shipping pieces outward iust enouah to clear the washer lb. Open iasher lid. Latch under Ihe dryer will hold lid open.

Pull three straps with completely out of wa

Numbers correspond

to steps

Shlpplng Strap with key.

NOTE: Use one hand to hold down agltator when removing shipplng straps. After straps ara removed release agitator, it will move upward.

10.

Read label. Firmly jerk then pull one of the three shipping straps up until strap with key is.co?nplelely removed horn washer. Repeat for other two shipping straps.‘Put straps in the same area as rear corner shipping pieces.

r

11.

Remove label.

Take hoses out of basket.

1 Place hoses with other parts.

Release washer lid by pushing up on latch. Close lid.

:Do ns move foam shipping

:piea 1-n the washer and

dtyel

il unit is in place.

PANEL C

Image 4
Contents Laundry Center ALL Governing Codes SeeNema Supply CordUse Duct Tape to peal all joints Four Inch Metal Exhaust Duct isPanel B Shlpplng Strap with key Numbers correspondPanel C Lo open FllMove washer/dryer close Panel DCongratulations NEL EAlternate electrical connection Alternate exhaust methods4NEL F Neutral Replace the terminal block coverPanel G Replace lermitw Mock cover Cold Wster Inlet Recess Width Recessedarea hlstructionsPrepared by KitchenAid, Sl. Joseph, Michigan