USING YOUR
WASHER
Understanding Washer
Cycles
When the Cycle Control knob is set to a number and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer begins agitating immediately after filling; agitation occurs with the washer lid up or down.
During agitation, the agitator creates a continuous rollover action that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These pauses are normal for washer operation.
WASHRINSE
1. Fill | 1. Fill |
2. Wash | 2. Rinse |
selected |
|
time |
|
3. Drain† | 3. Drain |
No agitation | No agitation |
4. Spin | 4. |
| rinse |
| 5. Spin |
† The Permanent Press | 6. Off |
cycle partially drains, |
|
fills, agitates briefly, and |
|
drains. |
|
Loading
Loading suggestions
For these suggested
SUPER CAPACITY PLUS WASHERS
Heavy Work Clothes | 1 coverall |
3 pair pants | |
3 shirts | 1 overall |
4 pair jeans |
|
|
|
Delicates | 2 bras |
3 camisoles | |
1 quilted robe | 2 nighties |
4 slips | 1 baby’s dress |
4 panties |
|
|
|
Towels |
|
10 bath towels | 14 wash cloths |
10 hand towels | 1 bath mat |
|
|
Mixed Load | 2 shirts |
3 double sheets | |
4 pillowcases | 2 blouses |
8 | 8 handkerchiefs |
6 pair shorts |
|
|
|
|
|
Normal Washer Sounds
Your new washer may make sounds your old one didn’t. Because the sounds might be unfamiliar, you may be concerned about them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a lower water level. This can cause a clicking sound from the upper part of the agitator.
During drain
If water is drained quickly from your washer (depending on your installation), you may hear air being pulled through the pump during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear gears engaging.
5