ENGLISH
Preparing the remote controller
This section is only for KD-AR200.
Before using the remote controller:
•Aim the remote controller directly at the remote sensor on the main unit. Make sure there is no obstacle in between.
Remote sensor
•Do not expose the remote sensor to strong light (direct sunlight or artificial lighting).
Installing the battery
When the controllable range or effectiveness of the remote controller decreases, replace the battery.
1. Remove the battery holder.
1)Push out the battery holder in the direction indicated by the arrow using a ball point pen or a similar tool.
2)Remove the battery holder.
(back side)
2. Place the battery.
Slide the battery into the holder with the
+side facing upwards so that the battery is fixed in the holder.
Lithium coin battery (product number: CR2025)
3. Return the battery holder.
Insert again the battery holder by pushing it until you hear a clicking sound.
(back side)
WARNING:
•Store the battery in a place which children cannot reach.
If a child accidentally swallows the battery, immediately consult a doctor.
•Do not recharge, short, disassemble or heat the battery or dispose of in a fire.
Doing any of these things may cause the battery to give off heat, crack or start a fire.
•Do not leave the battery with other metallic materials.
Doing this may cause the battery to give off heat, crack or start a fire.
•When throwing away or saving the battery, wrap in tape and insulate; otherwise, it may cause the battery to give off heat, crack or start a fire.
•Do not poke the battery with tweezers or similar tools.
Doing this may cause the battery to give off heat, crack or start a fire.
CAUTION:
DO NOT leave the remote controller in a place (such as dashboards) exposed to direct sunlight for a long time. Otherwise, it may be damaged.
6