FAULT DIAGNOSIS
WHY DOES IT HAPPEN?
INDICATOR LAMP DOES NOT GLOW.
qCheck if the machine is ON.
qCheck for loose connections in plug/socket.
WATER DOES NOT ENTER MACHINE/DETERGENT NOT
BEING FLUSHED INTO DRUM.
qCheck water supply
qPorthole door not firmly closed
qWater tap not turned on
qBent inlet hose
qSieve on inlet valve clogged
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY./
EXCESSIVE FOAM IN THE DRUM.
qDetergent used is not a front loading washing machine
detergent
qExcessive detergent used
WATER LEAKAGE FROM THE MACHINE.
qInlet/Outlet hose connection loose
qCoin trap cover or drain plug not screwed on properly qInlet hose leaking
MACHINE DOES NOT DRAIN. qOutlet hose end above 1 mtr. from floor level
MACHINE VIBRATES STRONGLY DURING SPINNING.
qMachine not levelled properly
qClothes not loaded as instructed
34
rUse of extension cord not recommended since it may not be properly earthed.
rUse ISI marked sockets of reputed make for preventing loose contact of power supply cable.
Ensurethat there is a firm connection between the 3 PIN PLUG and SOCKET, else it may result in sparking and subsequent failure of 3 pin plug.
Ensurethat L,N,E is as per the Fig. Shown
rWashing machine should always be connected to socket with 16 Amps MCB or other automatic short circuit protection devices.
CAUTION :- The producer/Manufacturer declines any responsibility for damage caused by failure to observe this rule. You are therefore advised to check that your household supply has an efficient earth.
11